Zhermack Zetaplus C Silicone Intro Kit :-

1 x 900ml Putty + 1 x 60ml Catalyst Tube + 140ml Light Body

Zhermack Zetaplus Indurent Catalyst Gel :

Features:-

High initial flowability

Green colour

Spearmint flavour

Reduces mucous compression in the phase of insertion in the oral cavity

Excellent hardness after setting

In the two-stage technique, it acts perfectly as a special tray

In double mixing, it adapts to the consistency of low-viscosity fluid

Variable working and setting times according to catalyst quantity ( Indurent gel )

Key Specifications:-

ISO 4823 – ADA 19 Type 0 Putty Consistency

Mixing time 30”

Total working time (23°C/73°F) 1′ 15”

Time in mouth 3′ 15”

Setting time (23°C/73°F) 4′ 30”

Compressive deformation (min-max) 2 -5 %

Elastic recovery >98%

Dimensional stability (after 24 h) <-0.2%

ZETAPLUS / ZETAPLUS SOFT – INSTRUCTIONS FOR USE :-

Dosage: Use the measuring spoon to dose the required quantity of Zetaplus and spread it out over your hand (note: for the correct dosage the putty should be level with the top of the measuring scoop). Press the rim of the measuring scoop onto the putty once for each measure dosed. For each measure of material, apply two strips of Zhermack Indurent Gel as long as the measuring scoop (4 cm.)

Mixing :

Fold and knead the putty energetically with your fingertips for about 30 sec., until the colour is even, without any stripes

Spread out the putty over the impression tray. The working time including mixing time is about 1 min. 15 sec.

Put into the mouth and wait until it is set, which will take about 3 min. 15 sec.

ORANWASH VL / ORANWASH L / THIXOFLEX M – INSTRUCTIONS FOR USE

Dosage: Extrude the required quantity, observing the dosage scale on the mixing block. Then dose a quantity of Zhermack Indurent Gel equal to the length of the fluid. When using Zhermack Indurent Liquid, dose one drop of hardening liquid for each notch of fluid.

Mixing :

Mix energetically with the spatula, and then carefully spread the mixture out, pressing it over the mixing block to eliminate any air which may have been incorporated into the mixture. Repeat this operation until the mix is even in colour.

Mixing time should ideally be about 30 sec.

Apply the mixture to the impression tray with a spatula or a syringe for elastomers.

The working time of c-silicones including mixing time is about 1 min. 30 sec.

Put into the oral cavity and wait for the mix to harden, which will take about 3 min. 30 sec.